How To Properly Install Metal Siding (PU Foam Wall Panel)?

Metal Siding (PU Foam Wall Panel), also known as metal embossed exterior wall insulation decorative board, with its excellent insulation performance and rich realistic decorative effect, has won the recognition and love of the domestic market, in the domestic market has achieved vigorous development. 　　

Today mainly introduce the installation of Metal Siding (PU Foam Wall Panel), in fact, as mentioned above, the correct installation of Metal Siding (PU Foam Wall Panel) on the building is very simple, only need a simple five steps to complete. 　
　

First, the preparation stage. After the order of Metal Siding (PU Foam Wall Panel) and its accessories to the scene, also need to prepare the installation of plate and accessories tools, mainly: expansion screws (for concrete and cement brick walls), swallowtail nails (for steel structures), drill guns, air nail guns (not required), marker pen, tape measure, rubber hammer, cutting machine, etc. 　
　
Second, install the attachment base. Before installing the Metal Siding (PU Foam Wall Panel), the plate fitting base is installed, including the lifting parts, closed parts, wrap edge, middle seam, yin and yang angle, etc. 　
　
Third, install the plate. After installing the accessory base, install a Metal Siding (PU Foam Wall Panel) horizontally from top to bottom (some patterned panels can also be installed vertically without water resistance), all panels must have the mother port facing down and the male port up, after installing a plate, with expansion screws or swallowtails Nails secure it to the wall (it is recommended to secure a nail every 60cm), then point the mother of the two plates down at the male port of one plate and tap the interface between the two plates with a rubber hammer to ensure that the connection between the two plates is tight enough. Then secure the two plates to the wall with expansion screws or ostrings, and then install the other plates in the same way. It is important to note that when the wall size is not the same as the sheet size, the cut needs to be measured before installation can continue.

Fourth, install the attachment cover. After installing all the Metal Siding (PU Foam Wall Panel)s, press the attachment cover the base. If it is an accessory of the same material, secure it to the wall with screws and seal it with waterproof glass glue. 　　

Fifth. Tear off the protective film on the surface of the Metal Siding (PU Foam Wall Panel). In order to protect the outer surface of the Metal Siding (PU Foam Wall Panel) from scratches during handling, all factory plates will be coated with a protective film on the surface. So when the installation of the plate is complete, the protective film can be torn off, so that the building can be completely new.